3 Keyboard Control Speed Dome
3.1 Cable Connection
Please connect keyboard A/B line to speed dome A/B line connection.
3.2 Keyboard Setup
a) Please make sure keyboard A/B line and speed dome A/B line connection is right.
b) Set speed dome address so that the speed dome address and the keyboard RS485
address are the same.
c) Go to the zones interface of the keyboard and then select the type as SD. Please refer to
chapter 2.3.2.
Note
Please select protocol according to the speed dome type. The default setup is DH-SD
(There are some other popular protocols such as PELCOD, PELCOP). The step is 8.
Please login WEB of the speed dome, from main interface->Setup->System->PTZ to
view speed dome address, protocol, COM setup and etc.
d) After the setup, click 【ESC】 to exit control point control interface. System pops up a
dialogue box you can click 【ENTER】 to save data or click 【ESC】 to cancel setup.
3.3 Operation
On the keyboard, click 【ID】 to go to the control point interface to set speed dome ID to connect to
the speed dome.
After successful connection, the interface is shown as below. See Figure 3-1.
Figure 3-1
Step: The speed dome adopts variable step mode by default. The speed dome movement
becomes faster along with the angle of the joystick becomes larger.
The lens movement supports 8 directions. It includes: up/down/left/right/top left/top
right/bottom left/bottom right. Please use the joystick to control.
3.3.1 Speed Dome Menu
Set mode: Click 【Menu】 button to go to the speed dome menu setup interface.
Use joystick up/down or the Iris ± to control the selected menu item up/down.
Use joystick left/right or the focus ± to control the selected menu contents.
Click 【ENTER】 to go to the next-level menu, click 【ESC】to exit the menu. Move to
select the Back and then click 【ENTER】, you can go back to the previous level.
To Next Page
Loading...
