Dahua NKB1000-E - Iris;Zoom;Focus; Preset; Scan

14
 On the speed dome, click 【ESC】 to go back to PTZ control interface.
3.3.2 Iris/Zoom/Focus
3.3.2.1 Iris
On the keyboard, click 【IRIS】 button, use button 【+】and【-】or turn joystick up/down to
control the iris.
3.3.2.2 Focus
On the keyboard click 【FOCUS】 button, use button 【+】and【-】or turn joystick left/right to
control the focus.
3.3.2.3 Zoom
On the keyboard click 【ZOOM】 button, use button 【+】and【-】or turn joystick clockwise or
counter clockwise to control the zoom.
3.3.3 Preset
Shortcut Mode
 On the Set mode, use keyboard to input 【No.】+【Preset】, you can set a preset quickly.
 On the Use mode, use keyboard to input 【No.】+【Preset】, you can set a preset quickly.
General Mode
On the keyboard click 【PRESET】, the interface is shown as below. See Figure 3-2.
Figure 3-2
3.3.3.1 Set Preset
Input preset number and then select 【Set】, click 【ENTER】 to save preset setup.
3.3.3.2 Go to preset
Input preset number and then select 【Goto】, click 【ENTER】 to go to the corresponding
preset position.
3.3.3.3 Delete preset
Input the preset number and then select 【Del】, click 【ENTER】 to remove it.
3.3.4 Scan
Shortcut Mode
On the Use mode, use keyboard to input 【No.】+【Scan】, you can call a scan. Click
【Scan】to stop it.
General Mode
On Set mode, click 【SCAN】 button, the interface is shown as below. See Figure 3-3.