Dahua NKB1000-E - Logout; General Function; Playback

19
c) Input ID, device name, IP address.RS232, RS485 you set on control point interface, Click
【ENTER】 to begin search.
System auto connect to the DVR after successfully search operation.
Tips
Click 【ID】 on the keyboard and then input ID number. Click 【ENTER】 to quickly find the
device.
4.2.2 Logout
Click 【ID】 on the keyboard and then click 【ESC】 to exit current menu.
4.2.3 General Function
4.2.3.1 Press one by one
 【No.】+【Split】: It is to Control split.
For example, input 16 and then click split button, you can realize 16-split function on the
DVR.
If you use the joystick now:
 【Left/right】: switch between 1～16/17～32.
 【Up/down】: DVR split in 1/4/9 or 25/32.
 【No.】+【CAM】:Select corresponding channel.
Input 9 and then click CAM button, the DVR displays the video from channel 9.
 【No.】+【PTZ】: Control the PTZ of the corresponding digital channel.
4.2.3.2 Press at the same time
 【AUX+1】：Record
 【AUX+2】：Open DVR PTZ control, click FN+1 to switch page.
 【FN+1】：Aux function.
 【FN+2】：Tour（The macro of the DVR shall be enabled.）
 【FN+3】：Control electronic zoom.
4.2.4 Playback
Click 【PLAY】 on the keyboard, you can go to the DVR search interface. Use joystick to control
the playback buttons such as stop, fast play, slow play and etc. Click 【ENTER】 to confirm. See
Figure 4-1.
Figure 4-1
SN
Function
SN
Function
SN
Function
7
Play
8
Stop
9
Playback
4
Slow play
5
Play
backward
frame by
frame
6
Previous
record
1
Fast play
2
Play frame
3
Next record