Dahua NKB1000-E - Pan; Tour

15
Figure 3-3
Please follow the steps listed below.
a) Select Set and then click 【ENTER】, you can see an interface shown as in Figure 3-4.
Figure 3-4
b) Use 3D joystick to select left limit and right limit.
c) Click 【ENTER】 to complete setup.
 Select start and then click 【ENTER】,system begins to scan according to the left/right
limit you set.
 Select stop and then click 【ENTER】, system stops scan.
3.3.5 Pan
Shortcut Mode
On the Use mode, click 【Pan】button on the keyboard, the speed dome begins pan. Click
【Pan】again to stop it.
General Mode
On Set mode, click 【PAN】 button on the keyboard, the interface is shown as below. See
Figure 3-5.
Figure 3-5
 Select start and then click 【ENTER】button, system begins pan operation.
 Select stop and then click 【ENTER】button, system stops pan operation.
3.3.6 Tour
Shortcut Mode
On the Set mode, use keyboard to input 【No.】+【Tour】, you can call a tour. Click 【Tour】
again to stop it.
General Mode