Dahua NKB1000-E - Pattern

16
On Set mode, click 【TOUR】 button on the keyboard, the interface is shown as below. See
Figure 3-6.
Figure 3-6
3.3.6.1 Set tour
a) Select Set item, the interface is shown as in Figure 2-10.
Figure 3-7
b) Input a value at the tour No.
c) Add/Delete preset to/from the tour.
 Input preset No. and then select PresetAdd, click 【ENTER】 button to add the input
preset to the tour.
 Input preset No. and then select PresetDel, click 【ENTER】 button to delete the input
preset from the tour.
Note
You can add several presets to add to a tour.
3.3.6.2 Call tour
 Select Start and then click 【ENTER】, speed dome begins tour.
 Select Stop and then click 【ENTER】, speed dome stops tour.
 Select Delete and then click 【ENTER】, speed dome removes the tour.
3.3.7 Pattern
Shortcut Mode
On the Use mode, use keyboard to input 【No.】+【Pattern】, you can call a pattern. Click
【Pattern】again to stop it.
General Mode
On Set mode, click 【PATTERN】on the keyboard, the interface is shown as below. See Figure
3-8.
Figure 3-8