3.6.1.1.3 PPPoE
PPPoE interface is shown as below. See Figure 3-19.
Input “PPPoE name” and “PPPoE password” you get from your ISP (Internet service provider).
Click OK button, you need to restart to activate your configuration.
After rebooting, device will connect to internet automatically. The IP in the PPPoE is the device
dynamic value. You can access this IP to visit the device.
Figure 3-19
3.6.1.1.4 DDNS
DDNS setup interface is shown as in Figure 3-20.
You need a PC of fixed IP in the internet and there is the DDNS software running in this PC. In
other words, this PC is a DNS (domain name server).
In network DDNS, please select DDNS type and highlight enable item. Then please input your
PPPoE name you get from you IPS and server IP (PC with DDNS). Click OK button and then
reboot system.
Click Ok button, system prompts for rebooting to get all setup activated.
After rebooting, open IE and input as below:
http：//(DDNS server IP)/(virtual directory name)/webtest.htm
To Next Page
Loading...