Dahua SMART PSS - Page 27

23
Figure 3-20
Please refer to the following sheet for detailed information.
Parameter
Function
Server Type
You can select DDNS protocol from the dropdown list and then
enable DDNS function.
Server IP
DDNS server IP address.
Server Port
DDNS server port.
Domain Name
Your self-defined domain name.
User
The user name you input to log in the server.
Password
The password you input to log in the server.
Update interval
Device sends out alive signal to the server regularly.
You can set interval value between the device and DDNS server
here.
3.6.1.1.5 IP Filter
IP filter interface is shown as in Figure 3-21. You can add IP in the following list.
After you enabled whitelist function, only the IP listed below can access current device.
If you enable blacklist function, the following listed IP addresses can not access current device.