Dahua SMART PSS - Page 50

46
Parameter
Note
Arm/Disarm
Period
Set alarm arm/disarm period.
Click set pop up Arm/Disarm Period box for setup.
Anti-dither
Means only record one motion detection event within the period. Value range 0s～
100s.
Record
Channel
If select the parameter, then alarm record the channel.
Go to “Record >Record Control” and select auto record.
Record Delay
Means when alarm link is end, motion detection record will remain for a period of
time before stop.
Alarm Output
If select the parameter, then enable alarm link output port, so when alarm occurs, it
can link corresponding alarm output device.
Output Delay
Means when alarm link ends, alarm will remain for a period of time before stop.
Capture
If select this parameter, then select this parameter, then this channel config motion
detection snapshot function.
Video Matrix
If select this parameter, then enable matrix function.
Send EMAIL
If select this parameter, then when alarm occurs, it send Email to user.
Alarm Upload
If select this parameter, then when alarms occurs, alarm will be sent to center.
SMS
If select this parameter, then when alarm occurs, user will receive SMS.
Face Detect is shown in Figure 3-50.