Dahua SMART PSS - Page 51

47
Figure 3-50
Parameter
Note
Enable
If select this parameter, it will link alarm.
Arm/Disarm
Period
Set alarm arm/disarm period.
Click setup to pop up arm/disarm period box.
Dynamic
Track
If select this parameter, then it enable dynamic trick.
Record
Channel
If select this parameter, then the channel has record of alarm.
Go to “Record > Record Control” and select “auto” record.
Record Delay
Means when alarm link ends, motion detection delays for a period of time.
Alarm Output
If select this parameter, then enable alarm link output port, when alarm occurs, may
link alarm output device.
Output Delay
Means when alarm link ends, alarm delays for a period of time.
Capture
If select this parameter, then it configures dynamic snapshot function for this
channel.