129
4.2.4.3 Abnormality
Figure 4- 62
Please see Figure 4- 62.
Event type: The abnormal events includes: no disk, disk error, capacity warning, net error, IP
conflict and MAC conflict. You can set linkage among these events.
Enable: Check enable box.
Alarm out: You can set event alarm out channel to alarm.
Alarm out delay: After alarm out event ends, alarm delays within 10 to 300s.
Alarm upload: System can upload the alarm signal to the network (includes the alarm centre.)
Email: If you enable this function, system can send out email to alarm the specified user.
Show message: Show alarm message on local screen.
Buzzer: Check it to enable, device will buzzer when alarm occurs.
4.2.4.4 Record
Record has main stream and sub stream available to select. Here you can set mode in auto,
manual and stop for each channel. Please see Figure 4- 63.
To Next Page
Loading...
