14
2 Open-Package Inspection and Wiring
2.1 Inspection Procedure
When you receive video matrix platform, please check for obvious external damage. The material
of product package should be able to protect the product from majority impacts during
transportation.
Secondly please open the package, and check all accessories see if any part is missing. You
may refer to accompanied accessory bag. After you have checked that all parts are included, you
may remove protector on device.
Thirdly, please open device case to check front panel’s wiring, power line and see if the
connection between mainboard and interface board is loose.
2.2 Accompanied Assessory Bag
Accompanied assessory bag includes user’s manual and disk. When you unpackage the product,
please make sure all contents match the checklist.
2.3 Device Installation
At time of inserting mainboard and Function Card into chassis, please remove the protection
cover at connection interface of real panel.
In case of beep, it may be that either one of power modules is not well fixed. You may press
the small red button next to power module at the rear of device to cancel beep alarm.
To Next Page
Loading...
