AV encoding mode, frame rate, quality and other parameter
setting
It includes timing setting for general video record, motion detect
and external alarm.
To set serial function, baud rate and other parameters.
To set network address, video data transmission protocol and
other parameters and PPPoE, DDNS function.
To set motion detect’ sensitivity, area and handling (alarm
output and boot up video record) parameter, video loss, black
screen detection and etc.
To set communication protocol, baud rate and other parameters
with PTZ device.
Setting of menu output and monitoring tour parameter
Choose to restore factory settings for all or partial configs
△Note：User accounts do not have recovery function.
HDD management, emptying HDD and etc.
△Note：If you edit HDD property, then you must reboot the
system to make change effective.
To set up alarm for abnomaly event such as no HDD, HDD
error.
To boot up or shutdown channel schedule.
To modify user group and user account.
To set up auto maintenance for item requires it.
To config cubeless video wall output.
To config Raid for record storage.
To add, delete remote devices.
To Log off menu user, shutdown system, reboot system and
switch user.
3.2.2 Menu Operation
After you logged in, the system main menu is shown as below. Please see Figure 3- 22.
There are total five icons: setting, advanced, remote device, info, and shutdown.
Note: 1. Setting in all submenus will come effective only after you click save,
otherwise you will lose all modified settings. 2. If a check box is filled with or
checked, then it is available in corresponding text; otherwise, it is not available in the
text.
To Next Page
Loading...
