44
Figure 3- 33
Note: Since system time is very important, do not modify time casually unless
there is a must!
Before your time modification, please stop record operation first!
3.2.4.2 Encode
Encode setting interface is shown as below. Please see Figure 3- 34.
Figure 3- 34
Slot: To select the slot you want.
Channel: To select the channel you want.
Signal type: Please select from the dropdown list.
Type: Select from regular, detect and alarm.
Compression: System supports H.264.
Profile: Main and Baseline.
Resolution: System supports various resolutions, you can select from the dropdown list. The
standard definition main stream supports D1/HD1/2CIF/CIF/QCIF and the high definition
main stream supports 1080P/720P/D1 and etc. Please note the option may vary due to
different series.
Frame rate: Pal standard: 1 frame/s – 25 frame/s. NTSC standard: 1 frame/s – 30 frame/s.
Bit rate type: System supports two types: CBR and VBR. You cannot set image quality
under CBR. In VBR mode, you can set video quality. There are six levels ranging from 1 to 6.
The sixth level has the highest image quality.
Bit rate: To set bit stream value to change image quality. The higher the rate, the better the
image quality. There is recommended bit stream value for you to refer.
To Next Page
Loading...
