57
3.2.4.6.1 Motion detect
When the system detects dynamic signal that reaches preset sensitivity via analyzing video
image, motion detect alarm will turn on. The interface is shown below as in Figure 3- 49.
Figure 3- 49
Note: Please make sure you have enabled motion detect function as the check box
filled by ■.
Event type: from the dropdown list you can select motion detect type.
Slot: select slot to set.
Enable: ■ means selected.
Channel: select the channel to activate motion detect or select all to include all channels
under selected slot.
Region: Move cursor to set, and click enter. The interface is shown as in Figure 3- 50. The
green zone is current cursor position. Grey zone is the motion detect zone. Black zone is the
disarmed zone. Do remember click save button to save current setting. If you click ESC
button to exit the region setting interface system will not save your zone setting.
To Next Page
Loading...
