71
Figure 3- 68
Abnormality interface is shown as in Figure 3- 68. In menu, click advanced setting and then
click Abnormality.
Event type: There are several options for you such as disk error, no disk, disconnection,
IP conflict, MAC conflict and etc. You can set one and more events.
Enable: ■ as selected.
Alarm Out: Select channel to alarm out. When alarm occurs, system automatically
enables the alarm channel(s).
Latch: Alarm latches one period and stops. Unit is second with range between 10 and
300.
Show message: system can pop up the message in the local screen to alert you when
alarm occurs.
Alarm upload: System can upload the alarm signal to the network (including alarm centre)
if you enabled current function.
Send email: System can send out email to alert you when alarm occurs.
Buzzer: ■ as selected. Highlight the icon to enable this function. The buzzer beeps when
alarm occurs.
3.2.5.3 Record
You may manually control records from each slot, each channel and network devices. Please
see Figure 3- 69.
To Next Page
Loading...
