74
Figure 3- 72
Add Group
You can add group by inputting group name and then inputting some memo information if
necessary.
Enter add group interface and select rights over control panel, shut down, real-time monitor,
playback, record, record file backup, PTZ, user account, system information view, alarm
input/output setting, system setting, log view, clear log, upgrade system, control device and etc.
Please see Figure 3- 72.
Modify Group
The modify group interface is similar to Figure 3- 72.
Add User
Figure 3- 73
Add user interface is shown above as in Figure 3- 73.
There are four default users: admin/888888/666666 and hidden user “default”. The first three
users have passwords same as the usernames, respectively. Except user 6666, other users
have administrator right. Hidden user “default” is for system interior use only and cannot be
deleted. When there is no login user, hidden user “default” automatically login. You can set some
rights such as monitor for this user so that you can view some channel view without login.
After you enter add user interface, please input the user name, password, and select the group it
belongs to from the dropdown list. You may select same user more than once. You are able to
use this selected user on different clients at the same time. Then you can check the
corresponding rights for current user. User right cannot exceed group right.
For convenient user management, usually we recommend the general user right is lower than
the admin account.
To Next Page
Loading...
