Dahua VTH2421FB-P User Manual

9
Device initialization Figure 2-4
According to interface prompt, enter “Password” and “Confirm Password”, and click Step 2
“Next”. Select “Email” and enter your Email address. This Email address is used to
reset the password, so it is recommended that it should be set.
Enter default address in the browser to login WEB interface. Step 3
Default username is admin. Password is the new one set during initialization.
Select “Network Setting > Basic”. Step 4
The system displays “TCP/IP” interface, as shown in Figure 2-5.
TCP/IP Figure 2-5
Enter the planned “IP Address”, “Subnet Mask” and “Gateway”, and click “OK”. Step 5
After modification is completed, VTO reboots automatically, while the following two
cases occur at WEB interface.
 If PC is in the planned network segment, WEB interface jumps to new IP login
interface automatically.
 If PC is not in the planned network segment, login will be failed. Please add PC to
the planned network segment and login WEB interface again.
Login WEB interface again; select “Local Setting > Basic”. Step 6
The system displays “Device Properties” interface, as shown in Figure 2-6.

Dahua VTH2421FB-P Specifications

General

Brand	Dahua
Model	VTH2421FB-P
Category	Intercom System
Language	English