Dahua VTH5321GW-W - Adding Room Number

14
Add VTO Figure 4-8
Configure the parameters, and be sure to add the SIP server itself too. Step 3
Table 4-3 Add VTO configuration
Parameter
Description
Rec No.
The VTO number you configured for the target VTO. See the details
in "4.3.2 Configuring VTO Number."
Register Password
Keep default value.
Build No.
Available only when other servers work as SIP server.
Unit No.
IP Address
IP address of the target VTO.
Username
The user name and password for the web interface of the target
VTO.
Password
Click Save. Step 4
4.3.6 Adding Room Number
You can add the planned room number to the SIP server, and then configure the room number
on VTH devices to connect them to the network. VTO works as SIP server will be taken as an
example, and if you use other servers as SIP server, see the corresponding manual for the
details.
The room number contains 6 digits of numbers or letters or their combination at most, and it
cannot be the same as any other VTO numbers.
Log in to the web interface of the SIP server, and then select Household Setting > Step 1
Room No. Management.