43
Arm Figure 4-47
Select an arm mode. Step 2
There are four modes: Home, Away, Sleep, and Custom. Select as needed.
Enter the arm/disarm password, and tap OK. Step 3
You will hear beeps. It means that you have armed successfully.
The default arm/disarm password is 123456. If you want to change it, see "4.4.4.4
General."
If you selected Delay for the alarm status of an area, you will hear the beeps after
the delayed duration has passed.
4.7.2 Disarm
Make sure that areas you want to disarm are armed; otherwise you cannot disarm the
area.
If you are forced to enter arm/disarm password to disarm, you can enter the hijacking
password (enter the arm/disarm password in reverse order), and then the management
center will receive your asking for help information.
Elevator Control 4.8
Elevator control modules can be connected to the indoor monitor. You can make the elevator
come to your floor through the indoor monitor. Once elevator control module is connected,
there is an elevator control button on the main menu of the indoor monitor.
To Next Page
Loading...
