38
4.5.2 Alarm Settings
4.5.2.1 Wire Zone
Set alarm settings for eight areas, and then if emergencies happen, alarms will be triggered.
Tap , the Alarm interface is displayed.
Wire zone Figure 4-42
Table 4-8 SIP server description
Area numbers. There are 8 areas in total. They cannot be modified.
There are 8 types of alarms: Infrared, gas sensor, smoke sensor, urgency
button, door sensor, stolen, perimeter, and doorbell. Select alarm types
according to detector types.
Select NO (normally open) or NC (normally closed) according to detector
types. It shall be the same as detector type.
There are 5 statuses: Instant, delay, bypass, remote, and 24-hour
protection zone.
Instant: In Arm Mode, if you selected this status for an area, once
alarms are triggered, the indoor monitor will give out voice prompt
immediately.
Delay: In Arm Mode, if you selected this status for an area, once
alarms are triggered, the indoor monitor will give out voice prompt a
period later.
Bypass: If you selected the bypass status for an area, after the area
has been armed and alarms are triggered; there will be no voice
To Next Page
Loading...
