Dahua VTH5321GW-W - Page 45

39
Parameter
Description
prompt. Once the area is disarmed, alarm status will be back to
normal.
Remove: When you select Arm Mode and Disarm Mode for an area

in "at home mode", "away from home mode", "sleep mode", and
"customizable mode", the status of this area will not be changed.
24-hour protection zone: If you selected this status for an area, no

matter Arm on the main menu is selected or not, whenever alarms
are triggered, voice prompt will always be given out.
Enter (Sec.)
In the Arm Mode, after you have selected this status for an area, there will
be no voice prompt when you enter the area from a disarmed area within
the period you set; after that period has passed in the Arm Mode, voice
prompt will be given out.
This function is only available when you have selected Delay status for an
area.
Exit (Sec.)
In the Arm Mode, after you have selected this status for an area, there will
be no voice prompt unit you have exit the area within the period you set.
After that period has passed in the Arm Mode, voice prompt will be given
out when alarms are triggered.
 This function is only available when you have selected Delay status
for an area.
 If you have selected this status for more than one area, and then
prompts of the area with the longest period will be displayed on the
indoor monitor.
4.5.2.2 Enable 433
This function is only available for models ending with A.
Only after you have enabled 433, the Wireless Zone interface will appear.