40
Enable 433 Figure 4-43
4.5.2.3 Wireless Zone
On the WirelessZone interface, you can add alarm devices for alarm areas, and then if alarms
are triggered, alarm messages will be pushed to the indoor monitor.
Tap on the main menu. Step 1
Select Enable 433. Step 2
Enable 433. Step 3
Tap WirelessZone. Step 4
Tap Add. Step 5
The indoor monitor enters the paring mode.
Press the paring button on the alarm device. Step 6
Tap the device added, slide to the left, and then the delete button will appear. Tap deleting
button to delete the device that you selected.
To Next Page
Loading...
