16
The added room number is displayed. Click to modify room information, and click
to delete a room.
Add room number in batches
1) Enter the total number of floors, total number of rooms on one floor, 1st room No.
of the 1st floor, and 1st room No. of the 2nd floor as needed.
2) Click Add at the bottom left of the interface.
All the added room numbers are displayed. Click Refresh to view the latest status,
and click Clear to delete all the room numbers.
Configuring Indoor Monitor 4.4
When the indoor monitor is used for the first time, you need to select a language that you prefer,
initialize the indoor monitor to get a password to enter project setting interface and an email to
reset password. In addition, you need to configure parameters for all door stations (VTO) and
indoor monitors that are found on the indoor monitor you are operating.
4.4.1 Initialization
4.4.1.1 Quick Configuration for VTH (For Villa)
Power on the device.
Step 1
The language selection interface is displayed.
Select a language Figure 4-11
Select a language that you prefer. Step 2
Tap OK. Step 3
Welcome is displayed, and then the message Do you want to do quick configuration?
To Next Page
Loading...
