11
4 Configuration
This chapter introduces how to initialize, connect, and make primary configurations to VTOs and
VTHs to realize basic functions, including device management, calling, and monitoring. For details,
see the user manual.
Configuration Process
Before configuration, check each device and make sure there is no short circuit or open circuit.
Plan IP address for each device, and also plan the apartment number and room number you
need.
Configure VTOs. See "4.3 Configuring VTOs."
1) Initialize VTOs. See "4.3.1 Initialization."
2) Configure VTO numbers. See "4.3.2 Configuring VTO Numbers."
3) Configure VTO network parameters. See "4.3.3 Configuring Network Parameters."
4) Configure SIP Server. See "4.3.4 Configuring SIP Server."
5) Configure target room number and group call. See "4.3.5 Configuring Call No. and
Group Call."
6) Add VTOs to the SIP server. See "4.3.6 Adding VTO."
7) Add room number to the SIP server. See "4.3.7 Adding Room Numbers."
Configure VTHs. See the VTH user's manual.
Verify Configuration. See "4.4 Verifying Configuration."
VDPConfig
You can download the "VDPConfig" and perform device initialization, IP address modification and
system upgrading for multiple devices at the same time. For the details, see the corresponding user's
manual.
Configuring VTOs
Connect the VTO to your PC with network cable, and for first time login, you need to create a new
password for the web interface.
4.3.1 Initialization
The default IP address of VTO is 192.168.1.110, and make sure the PC is in the same network segment
as the VTO.
Connect the VTO to power source, and then boot it up.
Open the internet browser on the PC, then enter the default IP address of the VTO in the
address bar, and then press Enter.
To Next Page
Loading...
Need help?
General
