alarm ended. The value ranges from 1s to 300s.
This function is for motion detect only. Check the box here to
enable video matrix function. Right now system supports
one-channel tour function. System takes “first come and first
serve” principle to deal with the activated tour. System will process
the new tour when a new alarm occurs after previous alarm ended.
Otherwise it restores the previous output status before the alarm
activation.
You need to check the box here to enable this function. You can
set corresponding channel to snapshot when motion detect alarm
occurs.
System can pop up a message to alarm you in the local host
screen if you enabled this function.
Check the box here to enable this function. The buzzer beeps
when an alarm occurs.
System can upload the alarm signal to the center (Including alarm
center.
When 3G network connection is OK, system can send out a
message when motion detect occurs.
If you enabled this function, System can send out an email to alert
you when an alarm occurs.
You need to check the box here to enable this function. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs.
Here you can set PTZ movement when an alarm occurs. Such as
go to preset X. See Figure 5- 72.
Check the box here, system can record motion detect event log.
The video loss interface is shown as in Figure 5-73.
After analysis video, system can generate a video loss alarm when the detected moving
signal reached the sensitivity you set here.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest
setups, please refer to chapter 5.10.3.1.1 motion detect for detailed information.
To Next Page
Loading...
Need help?
General