Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please
enable the auto register function, the device can auto register to the proxy server.
Figure 5- 65
The server IP address or server domain name you want to
register.
The auto registration port value of the server.
The device ID allocated by the server.
The alarm center interface is shown as below. See Figure 5- 66.
This interface is reserved for you to develop. System can upload alarm signal to the alarm
center when local alarm occurs.
Before you use alarm center, please set server IP, port and etc. When an alarm occurs,
system can send out data as the protocol defined, so the client-end can get the data.
Figure 5- 66
Check the box to enable alarm center function.
The IP address and the communication port of the PC that has installed
the alarm client.
Select alarm upload time from the dropdown list.
You can use your cell phone to scan the QR code and add it to the cell phone client.
Via the SN from scanning the QR code, you can access the device in the WAN. Please
To Next Page
Loading...
Need help?
General