For rear facing
Locking lever is an equipment to securely install the child safety seat
into your car. Please use it.
You will find 2 locking levers, one on each side of the main body.
Please use it according to location of installment.
locking lever
Fastening
Unfastening
Locking lever and belt guide are equipments for secure installment of child safety seat with car’s seat
belt. Please use it. If you do not use it, safety seat might be in danger, as it would not be tightened
up for shocks and abrupt stop.
Firstly, check if your car seat can install this child safety seat (refer to p.2 as some seats are not allowed
to install this product). If you cannot install safety seat as shown in this manual, do not force it to fasten up.
In this case, the safety seat might not work properly and cause unexpected accident.
When you adjust locking lever, please be careful not to jam your finger.
How to use locking lever
11
Danger
Danger
1
3
2
1 2
Push the locking lever to the side.
Unfasten buckle of car’s seat belt.
Push locking lever to the side
and then separate car’s belt.
As shown above, fix the belt with locking lever,
and then pull out the belt as much as possible
and hang it on belt guide
Pull shoulder part of car’s seat belt to make it tight
as much as possible and insert it into locking lever.
Then, pull the lever to opposite direction and push to lock.
Shoulder belt of car
Belt guide
Locking lever
Caution
To Next Page
Loading...