Rear
facing
Forward facing
Whenever you seat the baby in the safety seat, pull out adjustment belt to tightly buckle up the baby.
If the belt cannot perform its function properly, it might risk a life or cause serious injury.
Danger
How to Use Baby Mode
Angle adjustment of back support at Baby Mode
Tight attachment of shoulder belt at Baby Mode
14
Set the child safety seat to angle
of level 4,
which is for rear facing.
1 2
Pull out rear facing lever
(angle adjusting lever)
and then push it to the back.
Unfasten buckle of front pad.
Pull out shoulder pad while pressing
adjustment button of the belt.
(Refer to ‘How to use buckle’ on p.10)
Seat the baby and then put on shoulder belt.
Remember to adjust height of shoulder belt
according to height of your baby’s shoulder.
(Refer to ‘Height adjustment of shoulder belt’ on p.9)
Fasten up front pad and buckle.
Pull out adjustment belt while pressing
adjustment button to securely
fasten up shoulder belt to the baby.
Lay down the main body
of the seat to level 4 (lowest level).
To check the right angle,
refer to the arrow on the side
of the main body.
1 2
3 4
Between the belt and the baby, make a gap that allows adult’s hand to move around
Caution
“Click”
to fasten
Pull
To Next Page
Loading...