Base Base
Waist belt of car should be fastened up to the
maximum for firm fixation, so it would not swing.
Caution
Push the locking lever located on the opposite side of
fastening plate to open.
Pull shoulder part of car’s seat belt to make it tight as much as
possible and insert it into locking lever.
Then, pull the lever to opposite direction and push to lock.
(Make sure to put the belt inside the locking lever and then push the lever strongly,
so it can hold the belt tightly.)
7
8
☆
26
7
8
Check the above list and if the main body swings more than 3cm, please re-install it according to above instruction.
Are height of shoulder belt and headrest of safety seat suitable?
Are fastening plate and buckle of car’s seat belt securely fastened up?
Is not car’s seat belt twisted?
Is car’s seat belt tightly fastened up?
Is shoulder belt of car strongly fixed inside the locking lever?
Does the main body swing more than 3cm when you shake it?
Firstly, make sure shoulder belt of car is properly inserted
into the locking lever. Put your weight to the safety seat,
and then strongly pull the shoulder belt of car while pushing
belt locking lever on side to fix it.
9
Checklist for Toddler Mode
Please check the below list after completing the installation.
☆
Installment
diagram viewed
from outside
the car
Installment
diagram viewed
from inside
the car
Completion
Checked
To Next Page
Loading...