Danger
How to install Baby Mode
(
Rear facing/rear installment
)
16
Pull the seat back to full upright position.
1
Caution
According to types of car’s seat belt, installment and
fixing methods vary. Please refer to check possible
and impossible seats for installment on p. 3 and then
install child safety seat in a right way.
For ELR/ALR 3-point safety belt, switch to ALR
function after installment. Do not fasten up shoulder
belt too tightly. If you have tightened up like shown
on the diagram, please re-start installment from start.
Warning
When you adjust locking lever, please be careful not
to jam your finger.
Adjust height of shoulder belt and headrest according
to the baby.
2
With angle adjusting lever,
change angle of the main body to level 4.
Put main body in opposite direction (rear facing) of driving.
Make sure the bottom of safety seat to closely touch
car’s seat as shown on the diagram.
3
4
To Next Page
Loading...