15 | Troubleshooting
Installer reference guide
234
EBLA09~16DA + EDLA09~16DA
Daikin Altherma 3 M
4P620241-1 – 2020.06
15 Troubleshooting
In this chapter
15.1 Overview: Troubleshooting .................................................................................................................................................... 234
15.2 Precautions when troubleshooting........................................................................................................................................ 234
15.3 Solving problems based on symptoms................................................................................................................................... 235
15.3.1 Symptom: The unit is NOT heating or cooling as expected .................................................................................. 235
15.3.2 Symptom: Hot water does NOT reach the desired temperature ......................................................................... 235
15.3.3 Symptom: The compressor does NOT start (space heating or domestic water heating) .................................... 236
15.3.4 Symptom: The system is making gurgling noises after commissioning................................................................ 236
15.3.5 Symptom: The pump is blocked............................................................................................................................. 237
15.3.6 Symptom: The pump is making noise (cavitation) ................................................................................................ 237
15.3.7 Symptom: The pressure relief valve opens ........................................................................................................... 238
15.3.8 Symptom: The water pressure relief valve leaks................................................................................................... 238
15.3.9 Symptom: The space is NOT sufficiently heated at low outdoor temperatures .................................................. 239
15.3.10 Symptom: The pressure at the tapping point is temporarily unusually high ....................................................... 240
15.3.11 Symptom: Tank disinfection function is NOT completed correctly (AH-error) .................................................... 240
15.4 Solving problems based on error codes................................................................................................................................. 240
15.4.1 To display the help text in case of a malfunction.................................................................................................. 241
15.4.2 Error codes of the unit ........................................................................................................................................... 241
15.1 Overview: Troubleshooting
This chapter describes what you have to do in case of problems.
It contains information about:
▪ Solving problems based on symptoms
▪ Solving problems based on error codes
Before troubleshooting
Carry out a thorough visual inspection of the unit and look for obvious defects such
as loose connections or defective wiring.
15.2 Precautions when troubleshooting
WARNING
▪ When carrying out an inspection on the switch box of the unit, ALWAYS make
sure that the unit is disconnected from the mains. Turn off the respective circuit
breaker.
▪ When a safety device was activated, stop the unit and find out why the safety
device was activated before resetting it. NEVER shunt safety devices or change
their values to a value other than the factory default setting. If you are unable to
find the cause of the problem, call your dealer.
DANGER: RISK OF ELECTROCUTION
WARNING
Prevent hazards due to inadvertent resetting of the thermal cut-out: power to this
appliance MUST NOT be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly turned ON and OFF by the utility.
To Next Page
Loading...
