Daikin Altherma 3 M - To Connect the User Interface

9 | Electrical installation
Installer reference guide
108
EBLA09~16DA + EDLA09~16DA
Daikin Altherma 3 M
4P620241-1 – 2020.06
3435
X2M
3 Fix the cable with cable ties to the cable tie mountings.
9.2.5 To connect the user interface
This topic describes the following:
▪ Connecting the user interface cable to the outdoor unit.
▪ Installing the user interface, and connecting the user interface cable to it.
▪ (if necessary) Opening the user interface after it is installed.
Connecting the user interface cable to the outdoor unit
Wires: 4×(0.75~1.25mm²)
Maximum length: 200m
[2.9] Control
[1.6] Room sensor offset
1 Open the service cover. See "To open the outdoor unit"[472].
2 Connect the user interface cable to the outdoor unit. Fix the cable with cable
ties to the cable tie mountings.
X5M.11
P1P2
+
PSU
X1B
X5M.12
X5M.16
X5M.15
4
3
2
1
a
a User interface: Required for operation. Delivered with the unit as accessory.