Need help?Do you have a question about the Daikin ARKC12RV2S and is the answer not in the manual?
General| Brand | Daikin |
|---|---|
| Model | ARKC12RV2S |
| Category | Air Conditioner |
| Language | English |
Steps to remove the stop valve cover and top panel from the outdoor unit.
Steps to remove the front panel of the outdoor unit.
Steps to remove the discharge grille from the outdoor unit.
Steps to remove the outdoor fan and its connectors.
Steps to remove the fan motor fixing frame.
Steps to remove the fan motor.
Disconnect terminal board wires and remove the wire fixture.
Disconnect key connectors like S80 (four way valve) and S20 (EEV).
Disconnect reactor connectors and component connectors S30, S40.
Disconnect connector S90 (thermistors) and remove the partition plate.
Remove the terminal board mounting plate from the right side panel.
Lift and remove the electrical box with the terminal board mounting plate.
Remove the outdoor temperature thermistor and the protection net.
Unfasten hooks and remove the right side panel.
Steps to remove the PCB by unscrewing and unhooking it.
Steps to remove discharge pipe and heat exchanger thermistors.
Steps to remove the reactor and the partition plate.
Steps to remove the top, outer, and inner sound blankets.
Steps to pull out the electronic expansion valve coil.
Steps to remove the four way valve coil and its terminal cover.
Steps to remove protection bushing and disconnect compressor wires.
Steps to remove putties and heat/remove the four way valve.
Steps to remove the terminal cover from the compressor.
Steps to remove protection bushing, wires, and putties.
Steps to heat pipes, remove nuts, and lift out the compressor.
To Next Page