Daikin BRC1E52A7 - Setting Method of the Cooling;Heating Selection Eligibility

Operation manual BRC1E52A7
21
4PW71265-1 – 10.2011
Setting Method of the Cooling/Heating Selection Eligibility
(VRV only)
Setting Changes
See "Cool/Heat Selection Eligibility" on page 22 for an explanation of the
cooling/heating selection eglibility.
1
Cool
Return Setting
Set to
Cool
28°C
Cool
Set to
Cool
28°C
• Continue pressing Operation Mode Selector button
of the remote controller for at least 4 seconds.
(During backlight lit)
A remote controller will not display
" " (Changeover under control) if a cooling/
heating selection eligibility is granted to the remote
controller.
• The display " " (Changeover under control) on each remote
controller connected to the same outdoor unit or BS unit will start
blinking.
* Vent mode setting changes are possible regardless of the
cooling/heating selection eligibility.
* If a cooling/heating selection eligibility is set in the "cooling/
heating selection remote controller" (
), all the remote
controllers will display "
" (Changeover under control). In this
case, no cooling/heating selection eligibility can be set in the
remote controllers.
Refer to the operation manual provided to the outdoor unit for the
details of the "cooling/heating selection remote controller".
• Set a cooling/heating selection eligibility as explained below.
Selection Settings
The display " " (changeover under control) will blink when the power is
turned ON for the rst time.
2
Cool
Set to
Cool
28°C
Cool
Set to
Cool
28°C
• Press Operation Mode Selector button of the
remote controller for which the selection eligibility
to be set.
Then the cooling/heating selection eligibility will be
set and the display
" " (Changeover under control) will disappear.
The display " " (Changeover under control)
will appear on the other remote controllers.
Basic Operation Method (Use of Direct Buttons)