Installer reference guide BRC1E53
45
4P419250-1 – 2015.10
Other Service Settings
20-4 Outdoor Unit Status
● Consult the outdoor unit thermistor temperatures.
SkyAir VRV
Th1 Outdoor air thermistor -
Th2 Heat exchanger thermistor -
Th3 Discharge pipe thermistor -
Th4 - -
Th5 - -
Th6 - -
20-5 Forced Fan ON
● Force the fan(s) ON for the individual indoor units.
● This function can be used to check which indoor unit number is associated with which indoor
unit.
20-6 Switch Main Sub Controller
● Swap the main and sub remote controller designation.
● Changing the main/sub designation requires to turn the power OFF and ON again.
NOTE
20-7 Filter Indicator
● Resets the timer of the lter indicator for all indoor units.
20-8 Test Filter Auto Clean
● Test if lter auto clean works.
● This function is only available if the Self Cleaning Decoration Panel is installed.
● When Filter Auto Clean is disabled (Disable Filter Auto Clean), the message "Auto lter clean
is disabled" will be shown when opening the Test Filter Auto Clean screen.
20-9 Brush/Filter Ind
● Resets the timer of the lter indicator for all indoor units.
● This function is only available if the Self Cleaning Decoration Panel is installed.
20-10 Disable Filter Auto Clean
● Enable/disable the use of the Filter Auto Clean function.
● When disabled, the message "Auto lter clean is disabled" will be shown when opening the
Test Filter Auto Clean and Filter Auto Clean screen.
● This function is only available if the Self Cleaning Decoration Panel is installed.
To Next Page
Loading...
