Daikin Comfora - Page 18

To Next Page

To Previous Page

4 | About the box

Installer reference guide

FTXTP-M_FTXTP-N

Daikin room air conditioner

4P728168-4 – 2023.03

f Dry battery AAA.LR03 (alkaline) for user interface

g User interface holder

h User interface

i Mounting plate

j Wireless LAN adapter

Main Page

Table of Contents2
About the Documentation4
About this Document4
Meaning of Warnings and Symbols5
General Safety Precautions7
For the Installer7
General7
Installation Site8
Refrigerant - in Case of R410A or R3211
Electrical12
Specific Installer Safety Instructions15
About the Box17
Indoor Unit17
To Unpack the Indoor Unit17
To Remove the Accessories from the Indoor Unit17
About the Unit19
System Layout19
Operation Range19
About the Wireless LAN19
Precautions When Using the Wireless LAN20
Basic Parameters20
Unit Installation21
Preparing the Installation Site21
Installation Site Requirements of the Indoor Unit21
Opening the Unit22
To Remove the Front Panel22
To Open the Service Cover23
To Remove the Front Grille23
Mounting the Indoor Unit24
To Install the Mounting Plate24
To Drill a Wall Hole25
To Remove the Pipe Port Cover25
Connecting the Drain Piping26
General Guidelines26
To Connect the Piping on Right Side, Right-Back, or Right-Bottom26
To Connect the Piping on Left Side, Left-Back, or Left-Bottom26
To Check for Water Leaks26
To Connect the Piping on Right Side, Right-Back, or Right-Bottom27
To Connect the Piping on Left Side, Left-Back, or Left-Bottom28
To Check for Water Leaks29
Piping Installation30
Preparing Refrigerant Piping30
Refrigerant Piping Requirements30
Refrigerant Piping Insulation31
Connecting the Refrigerant Piping31
About Connecting the Refrigerant Piping31
Precautions When Connecting the Refrigerant Piping31
Preparing Refrigerant Piping31
Pipe Bending Guidelines31
Guidelines When Connecting the Refrigerant Piping32
Pipe Bending Guidelines33
To Flare the Pipe End33
To Connect the Refrigerant Piping to the Indoor Unit34
To Check Refrigerant Piping Joints for Leaks after Charging Refrigerant34
Notice34
Electrical Installation36
About Connecting the Electrical Wiring36
Precautions When Connecting the Electrical Wiring36
Information36
Also Read the Precautions and Requirements in the "2 General Safety36
Guidelines When Connecting the Electrical Wiring37
Specifications of Standard Wiring Components39
To Connect the Electrical Wiring to the Indoor Unit39
Finishing the Indoor Unit Installation41
To Insulate the Drain Piping, Refrigerant Piping and Interconnection Cable41
To Pass the Pipes through the Wall Hole41
Refrigerant Piping Diameter41
To Fix the Unit on the Mounting Plate42
Closing the Unit42
To Re-Install the Front Grille42
To Close the Service Cover42
To Re-Install the Front Panel43
Wireless LAN Adapter Installation44
To Install the Adapter44
To Connect the Adapter with the Unit44
To Place the Adapter into the Unit45
To Check the Functionality of the Adapter46
Setting the Wireless LAN46
To Install the ONECTA App46
Configuration47
To Set a Different Channel of the Indoor Unit Infrared Signal Receiver47
Commissioning49
Overview: Commissioning49
Checklist before Commissioning49
To Perform a Test Run50
To Perform a Test Run in Winter Season50
Hand-Over to the User51
Disposal52
Technical Data53
Wiring Diagram53
Unified Wiring Diagram Legend53
Glossary56

Daikin Comfora - Page 18

Table of Contents

Other manuals for Daikin Comfora

Related product manuals