IM 1133-C
DIII-NET COMMUNICATION GATEWAY 17 www.DaikinApplied.com
Creating a New Zone and Setting the Intelligent Touch Controller Dead Band
1. From the main screen the zone “All” should be highlighted, as in Figure 15. From this screen press the Settings button in
the lower right corner, indicated with the red arrow.
Figure 15, All Zones Display on Intelligent Touch Controller
2. In the Settings Menu press the down arrow, select “System” and then press Execute.
Figure 16, System Settings Screen
3. When the System menu displays as in Figure 17, select “Zone/Group” then press “Execute”.
Figure 17, System Menu for Selecting Zone/Group
4. Make a new zone group populated only by the DIII-NET Communication Gateway as follows:
Under the “Zone List” box press the “Add” button and make sure the new zone group is highlighted.
To Next Page
Loading...
