IM 1133-C
DIII-NET COMMUNICATION GATEWAY 24 www.DaikinApplied.com
iTouch Manager Configuration
The iTouch Manager (iTM) also needs to be configured. This section shows how to add units to the iTM, change the icon for a
zone and how to set the dead band to zero. Refer to manuals EM11A017 and EM11A022 for more details regarding the
operation and commissioning of the iTouch Manager. The iTM manuals are available on www.daikinac.com.
If the Intelligent Touch Controller is being used, see the previous section “Intelligent Touch Controller Configuration”
Auto Register a Unit to the iTouch Manager
The iTouch Manager will often automatically detect units on a DIII network. However, most Daikin AHU’s must be added
manually. See the next section, “Manually Add a Unit to the iTouch Manager.” To automatically register a unit to the iTouch
Manager, proceed with the following steps:
1. Select the “Menu List” button from the bottom of the screen. See Figure 30.
Figure 30, iTouch Manager Home Screen
2. From the Menu List Screen, tap the 4 corners of the screen as shown in figure 31 to access the service login.
Figure 31, Accessing Service Login
3. Enter the password “daikin” and press OK. See Figure 32.
4. A red frame will appear around the edges of the screen when the service login is active, as seen in figure 33.
To Next Page
Loading...
