IM 1133-C
DIII-NET COMMUNICATION GATEWAY 38 www.DaikinApplied.com
Appendix B
Configurable Parameters
Table 4 defines the different parameters that are available in the D3 Set Up menu. The default values and acceptable ranges of
values are also included.
Table 2 DIII Set-Up Menu
Sets the Version of Intelligent Touch
Controller software
‘Std’ / ‘USw/Stp’ / ‘USw/oStp’
Particular address for unit
Saves particular DIII address
Yes / No (reverts back to no)
Selects which temperature to display
None, DAT, Space, RAT, OAT
This is a list of the menu items in the DIII Status Menu on the MicroTech III controller. Also listed is a description of the item,
its default value, range of values or enumerations, if it can be read or written to, and which controller can change the value of the
parameter. Most of the DIII Status Menu items read in values from the Intelligent Touch Controller and display them on the
MicroTech III controller. Not all menu items will always be shown on the MicroTech III controller. There are items that will not
show unless other parameters are set to a specific value. Refer to the OM 920 for more information.
Table 3 DIII Status Menu
Displays status of D3 Gateway
Auto, Cooling, Heating, Fan
Displays cooling set point
Displays heating set point
Displays fan speed parameter
Displays max load to enable economizer
Displays min load to enable economizer
Displays if Economizer is enabled
Displays software version
Displays valid Air-Net address
Displays valid Air-Net address
Displays valid Air-Net address
Displays valid Air-Net address
Selects OA unit address to displays setup for
Displays current OA address selected
To Next Page
Loading...
