Si04-960 Removal of Horizontal Blades / Vertical Blades
Removal Procedure 7
For reassembling.
1. Since the key pattern hook
is provided on the right side,
insert the edge of the blade
to the pivot while rotating it.
2. Fit the horizontal blade to
the other 2 pivots.
2. Remove the vertical blades.
1
Disengage the vertical
blades from the fixing
plate.
2
Remove the vertical
blades forward.
5 vertical blades are
integrated with the joint rod.
(Only one blade cannot be
exchanged.)
Step Procedure Points
(R2032)
Vertical blades
(R3090)
Fixing plate
(R2527)
To Next Page
Loading...
