OPERATION
INTELLIGENT EYE Operation
“INTELLIGENT EYE” is the infrared sensor which detects the human movement.
If no one is in the room for more than 20 minute, the operation automatically
changes to energy saving operation.
CAUTION
• Do not place large objects near the INTELLIGENT EYE sensor.
Also keep heating units or humidiers outside the sensor’s detection area.
This sensor can detect undesirable objects.
• Do not hit or violently push the INTELLIGENT EYE sensor. This can lead to
damage and malfunction.
To start
1. Press .
• “ ” appears on the LCD.
• The INTELLIGENT EYE lamp lights green.
• The lamp will be lit while human movements are
detected.
To cancel
2. Press again.
• The INTELLIGENT EYE lamp goes off.
• “
” disappears from the LCD.
Display
NOTE
Energy saving operation
• If no presence detected in the room for 20 minutes, the energy saving operation will start.
• This operation changes the temperature by +2°C in COOL / +2°C in DRY operation from the set
temperature. When the room temperature exceeds 30°C, the operation changes the
temperature by +1°C in COOL / +1°C in DRY operation from the set temperature.
• This operation decreases the airow rate slightly in FAN operation only.
Notes on INTELLIGENT EYE operation
• The air conditioner may go into energy saving operation even if
there are people in the area.
This may occur depending on the clothes the people are wearing
if there are no movements of the people in the area.
• Due to the position of the sensor, people might be exposed to
the airow of the indoor unit if they are close to the front side of
the indoor unit.
• Sensor may not detect moving objects further than 7m away.
(Check the application range)
• Sensor detection sensitivity changes according to indoor unit location, the speed of passersby,
temperature range, etc.
• The sensor could also mistakenly detects pets, sunlight, uttering curtains and light reected off
of mirrors as passersby.
Application range is as
follows.
90˚
7m
Vertical angle 90°
(Side View)
15
English
To Next Page
Loading...
