CARE
Care and Cleaning
Filter (small)
* For the applicable lter type, please refer to NOTE on
.
1. Open the front panel and pull out the air lter.
2. Take off the lters.
• Remove the lters from the 6 tabs.
• Hold the recessed parts of the frame and
unhook the 4 claws.
3. Clean or replace the lters.
[Cleaning]
Deodorizing lter (enzyme blue) [blue] or titanium apatite deodorizing
lter [blue-black]
3-1 Vacuum dust, and soak in lukewarm water or water for about 10 to 15 minutes if very
dirty.
3-2 After washing, shake off remaining water and let them dry in the shade.
• This lter can be renewed by washing it with water once every 6 months and we
recommend replacing it once every 3 years.
• Do not wring out the lter when removing water from it.
Dust collection lter (PM2.5) [white]
• Do not wash the lters as this will reduce their efciency.
• It is recommended to replace it once every 6 months.
[Replacement]
Remove each lter from the front grille by detaching them from the
6 tabs and then install the new lters.
• Do not throw away the lter frame.
• Dispose of the old lter as non-ammable waste.
• When attaching the lter, check that the lter is properly
set in the tabs.
4. Set the lters as they were and close the front
panel.
• Press the front panel at both sides and the center.
Notes on cleaning
For cleaning, do not use the materials as follows.
• Hot water above 40°C.
• Benzine, gasoline, thinner, other volatile oils.
• Polishing compound.
• Scrubbing brushes, other hard stuff.
24
To Next Page
Loading...
