Main Functions SiBE041029EC
27 Function and Control
End of Function
The function ends when the HOME LEAVE button is pressed again during HOME LEAVE
operation or when the POWERFUL button is pressed.
Setting Temperature and Airflow Rate
When using HOME LEAVE operation for the first time, set your preferred temperature and
airflow rate for HOME LEAVE operation.
1. Press the HOME LEAVE button.
Make sure is displayed on the remote controller.
2. Adjust the temperature with the or button.
3. Adjust the airflow rate with the FAN button.
HOME LEAVE operation will run with these settings the next time you start HOME LEAVE
operation. To change the recorded information, repeat steps 1 – 3.
Note: 1. The set temperature and airflow rate are recorded in the remote controller. When the remote
controller is reset due to battery replacement, the temperature and airflow rate for HOME
LEAVE operation needs to be set again.
2. The operation mode cannot be changed while HOME LEAVE operation is being used.
Initial setting Selectable range
Temperature Airflow rate Temperature Airflow rate
Cooling 25°C 18 ~ 32°C 5 steps, ,
Heating 25°C 10 ~ 30°C 5 steps, ,
<Cooling>
HOME LEAVE operation
Start
Stop
(R11660)
Time
Set temp.
Normal operation
Normal operation
HOME LEAVE operation
set temp.
(R22032)
Time
Set temp.
HOME LEAVE operation
To Next Page
Loading...
