SiBE041029EC Service Diagnosis
Service Diagnosis 54
Method 2
1. Press the center of the TEMP button and the MODE button at the same time to enter the
diagnosis mode.
The left-side number blinks.
2. Press the TEMP or TEMP button and change the number until you hear the two
consecutive beeps or the long beep.
3. Diagnose by the sound.
beep: The left-side number does not correspond with the error code.
two consecutive beeps: The left-side number corresponds with the error code but the
right-side number does not.
long beep: Both the left-side and right-side numbers correspond with the error code.
(The numbers indicated when you hear the long beep are the error code.
→ Refer to page 56.)
4. Press the MODE button.
The right-side number blinks.
(R4272)
(R14967)
(R4274)
(R4275)
(R14968)
To Next Page
Loading...
