Si20-701_B Troubleshooting by Remote Controller
118
3.16
C1
Transmission Error
(between Indoor Unit PCB and
Adaptor PCB)
Remote Controller Display
C1
Applicable Models
FCQG
Method of Error Detection
Check the condition of transmission between indoor unit
PCB and adaptor PCB using micro-computer.
Error Decision Conditions
When normal transmission is not conducted for certain
duration (15 seconds or more). After 60 seconds, error is
display on the remote controller.
Supposed Causes
îš„ Connection defect of the connector indoor unit PCB
and adaptor PCB
îš„ Defective indoor unit PCB
îš„ Defective adaptor PCB
îš„ External factor (Noise, etc.)
To Next Page
Loading...
Need help?
General
