Daikin FUY100FJV1 User Manual

Troubleshooting by Remote Controller Si20-701_B
57
1 Press the INSPECTION/TEST button to select
“inspection”. The equipment enters the inspection
mode. The “Unit” indication is displayed and the
Unit No. display shows blinking “
0
” indication.
2 Set the Unit No.
Press the UP or DOWN button and change the Unit
No. display until the buzzer (
∗
1) is generated from
the indoor unit.
∗
1 Number of beeps
3 short beeps: Conduct all of the following
operations.
1 short beep: Conduct steps 3 and 4.
Continue the operation in step 4 until
a buzzer remains ON. The
continuous buzzer indicates that the
error code is confirmed.
Continuous beep: No abnormality.
3 Press the MODE selector button.
The left “
0
” (upper digit) indication of the error code
blinks.
4 Error code upper digit diagnosis
Press the UP or DOWN button and change the
error code upper digit until the error code matching
buzzer (
∗
2) is generated.

The upper digit of the code changes as shown
below when the UP and DOWN buttons are
pressed.
∗
2 Number of beeps
Continuous beep: Both upper and lower digits
matched. (Error code
confirmed)
2 short beeps: Upper digit matched.
1 short beep: Lower digit matched.
5 Press the MODE selector button.
The right “
0
” (lower digit) indication of the error code
blinks.
6 Error code lower digit diagnosis
Press the UP or DOWN button and change the
error code lower digit until the continuous error code
matching buzzer (
∗
2) is generated.
The lower digit of the code changes as shown
below when the UP and DOWN buttons are
pressed.
"UP" button "DOWN" button
"UP" button
"DOWN" button

Daikin FUY100FJV1 Specifications

General

Brand	Daikin
Model	FUY100FJV1
Category	Air Conditioner
Language	English