12
English
RADIANT Operation
The RADIANT operation provides a comfortable environment with quiet and
currentless heating operation in addition to the HEAT operation mode. The
RADIANT operation has 2 operation modes.
To start RADIANT operation
Press 1. and select an HEAT operation.
Each pressing of the button advances the mode setting in sequence.•
AUTO DRY COOL HEAT FAN
“ • ” is displayed on the LCD.
Press 2. and select a RADIANT operation.
“ • ” is displayed on the LCD.
The RADIANT lamp lights red.•
This button can be used only in the HEAT operation mode.•
When the RADIANT operation starts, the temperature of the radiant panel increases.•
Display
RADIANT operation with HEAT
Auto fan speed
RADIANT operation
Gentle breeze
RADIANT1
Use this operation when the difference •
between the set temperature and indoor
temperature is large, or to warm up the room
quickly.
RADIANT2
Use this operation to prioritize quiet and •
currentless heating operation, or when the
noise from RADIANT1 operation bothers you.
The gentle breeze operation starts from the
beginning.
CAUTION
During the RADIANT operation, the surface temperature of the panel will be about 55°C at maximum.•
Even after the RADIANT operation is fi nished, the surface temperature of the panel of the air conditioner stays hot for a while. Do not touch the
air conditioner until the surface temperature of the panel decreases.
Be careful that children do not touch the surface of the panel.
NOTE
Notes on RADIANT operation
If RADIANT2 operation does not warm up the room, use HEAT or RADIANT1 operation.•
RADIANT1 can be used with POWERFUL operation. RADIANT2 cannot be used with the POWERFUL operation.•
This operation may not warm up the room adequately depending on conditions such as an extremely low outside temperature and lack of •
adequate performance.
The RADIANT operation uses the auto fan speed, so the airfl ow rate cannot be changed.•
When the indoor units are connected using a multi system, please refer to “Selecting the operation mode” in note for multi system. •
Page 27
►
01_EN_3P276869-1A.indb 1201_EN_3P276869-1A.indb 12 8/8/2012 4:18:14 PM8/8/2012 4:18:14 PM
To Next Page
