5
Name of Parts
Indoor Unit
Radiant panel
Front panel
Signal receiver and Indoor
unit ON/OFF switch
Display
Air outlet
Louvers (vertical blades)
The louvers are inside of the air outlet. •
Page 14
►
Room temperature sensor
It detects the air temperature around the unit.•
Flap (horizontal blade)
Page 14
►
TIMER lamp (yellow)
OPERATION lamp
(green)
RADIANT lamp (red)
Page 12
►
Signal receiver
It receives signals from the remote controller.•
When the unit receives a signal, you will hear •
a beep sound.
Case Sound type
Operation start beep-beep
Setting changed beep
Operation stop long beep
Indoor unit ON/OFF switch
Press this switch once to start operation.•
Press once again to stop it.
The operation mode refer to the following table.•
Mode Temperature setting Airfl ow rate
AUTO 25°C AUTO
This switch is useful when the remote controller is missing.•
Air inlet
01_EN_3P276869-1A.indb 501_EN_3P276869-1A.indb 5 8/8/2012 4:18:10 PM8/8/2012 4:18:10 PM
To Next Page
Loading...
