SiBE18-821_C Field Settings
Test Operation and Field Settings 159
BRC1E51A7
a Unit No.
b First code No.
c Second code No.
d Mode
Step Action Remote controller
1 Press and hold the [Cancel] button ( )
for 4 seconds to enter the Field setting
menu.
2 Use the buttons to select Field
setting list and push the [Menu/Enter]
button ( ).
3 Use the buttons to select the desired
Mode.
4 During group control, when setting by each
indoor unit (Mode 20, 21, 22 and 23 have
been selected), push the button to
highlight and buttons to select the
INDOOR UNIT NO. to be set. This
operation is unnecessary when setting by
group.
5 Highlight the second code No. to be
changed using the buttons, and use
the buttons to select the desired
second code No.
When setting by group, all of the
second code No. that may be set are
displayed as “*”.
6 Push the [Menu/Enter] button ( ) to
display the confirmation screen.
7 Use the buttons to select Yes and push
the [Menu/Enter] button ( ).
When multiple setting changes are
needed, repeat steps 3 to 7.
8 Push the [Cancel] button ( ) 2 times to
return to basic screen.
a
b
c
d
(R12878)
Field setting
Unit No Mode
list
Return Setting
Test operation ON/OFF
Register Service Contract
Field setting list
Group No. setting
Indoor unit Airnet No. set
Outdoor unit Airnet No. set
1/2
Return
Field setting
Setting
(R12879)
To Next Page
Loading...
Need help?
General
