SiBE18-821_C SA Indoor Unit - FFQ, FCQ, FDBQ, FBQ, FHQ Series
Operation Manual 317
•
The timer is operated in the following two ways.
Programming the stop time ( )
.... The system stops operating after the
set time has elapsed.
Programming the start time ( )
.... The system starts operating after the
set time has elapsed.
•
The timer can be programmed a maximum
of 72 hours.
•
The start and the stop time can be
simultaneously programmed.
9 English
FAN SPEED CONTROL
Press FAN SPEED CONTROL button.
UP AND DOWN DIRECTION
Up and down adjustment
MOVEMENT OF THE AIR FLOW FLAP
NOTES
Operate in the following order.
Heating
PROGRAM TIMER OPERATION
AIR FLOW DIRECTION
ADJUST
Press the AIR FLOW DIRECTION
ADJUST button to select the air
direction as shown below.
DISPLAY appears and the
air flow direction
continuously varies.
(Automatic swing setting)
Press AIR FLOW
DIRECTION ADJUST
button to select the air
direction of your choice.
DISPLAY vanishes the air
flow direction is fixed
(Fixed air flow direction
setting).
For the following conditions, micro computer
controls the air flow direction so it may be
different from the display.
Operation
mode
Operation
conditions
•
If you try cooling or programmed
drying, while the flaps are facing
downward, air flow direction may
change unexpectedly. There is nothing
wrong with the equipment. This serves
to prevent dew formed on parts in the
air discharge outlet from dripping.
•
Operation mode includes automatic
operation.
High or Low fan speed can be selected.
The micro computer may sometimes control
the fan speed in order to protect the unit.
•
The movable limit of the flap is changeable.
Contact your Daikin dealer for details
.
•
When starting operation
•
When room temperature
is higher than the set
temperature
•
At defrost operation (The
flaps blow horizontally to
avoid blowing cold air
directly on the occupants
of the room.)
To Next Page
Loading...
Need help?
General
